Due to changes in the system mechanism of Synology and QNAP, the command for hard disk hibernation has become ineffective. However, there is still a solution for QNAP.
- SSH into your QNAP, use "sudo -i" to obtain administrator privileges, and use the following command to find the hard disk you want to put into hibernation:
qcli_storage -d
These two commands are used to check if the hard disk you want to put into hibernation is under the system partition and synchronized with RAID (including the built-in hard disks and m2 disks before removal).
For example, if you find that the first hard disk you want to put into hibernation is "sda".
NVMe disks are not named using "sdx" naming convention.
mdadm /dev/md9 --fail /dev/sda1
mdadm /dev/md13 --fail /dev/sda4
mdadm /dev/md9 --fail /dev/nvme1n1
mdadm /dev/md13 --fail /dev/nvme1n1
Then, use these two commands to remove the RAID and set the hard disk hibernation time in the QNAP system. During this period, the hard disk will not be accessed or work, and it will enter hibernation.
- Alternatively, if you have multiple hard disks, you can remove the RAID all at once. The command is as follows (this is for solving the hibernation of 10 hard disks at once). Remember to obtain administrator privileges.
mdadm /dev/md9 --fail /dev/sda1
mdadm /dev/md9 --fail /dev/sdb1
mdadm /dev/md9 --fail /dev/sdc1
mdadm /dev/md9 --fail /dev/sdd1
mdadm /dev/md9 --fail /dev/sde1
mdadm /dev/md9 --fail /dev/sdf1
mdadm /dev/md9 --fail /dev/sdg1
mdadm /dev/md9 --fail /dev/sdh1
mdadm /dev/md13 --fail /dev/sda4
mdadm /dev/md13 --fail /dev/sdb4
mdadm /dev/md13 --fail /dev/sdc4
mdadm /dev/md13 --fail /dev/sdd4
mdadm /dev/md13 --fail /dev/sde4
mdadm /dev/md13 --fail /dev/sdf4
mdadm /dev/md13 --fail /dev/sdg4
mdadm /dev/md13 --fail /dev/sdh4
- Note that the commands will become ineffective after restarting the QNAP. After restarting, you can execute the commands again. It is convenient to use FinalShell, you can add the commands by right-clicking and selecting "Add Command" below, save the hibernation commands, and execute them with a single click after each restart (remember to obtain administrator privileges).
